Please wait a minute...
材料导报  2019, Vol. 33 Issue (z1): 519-522    
  高分子与聚合物基复合材料 |
端乙烯基硅氧烷对水性丙烯酸树脂的改性
张政, 刘标, 高延敏
江苏科技大学材料科学与工程学院,镇江 212003
Modification of Aqueous Acrylic Resin by End-vinyl Siloxane
ZHANG Zheng, LIU Biao, GAO Yanmin
School of Materials Science and Engineering, Jiangsu University of Science and Technology, Zhenjiang 212003
下载:  全 文 ( PDF ) ( 3012KB ) 
输出:  BibTeX | EndNote (RIS)      
摘要 溶剂型传统涂料导致众多的环境污染问题,因此需要研究出新的低VOC排量的涂料。水性丙烯酸树脂是比较好的环保涂料,由于丙烯酸树脂性能存在缺陷,在其水性化的同时需要改性。有机硅具有很好的高低温性能、较好的疏水性以及可以交联等特点。本工作将含乙烯基的硅氧烷KH570引入丙烯酸主链得到改性树脂,改性树脂吸水率明显降低,接触角提高了13.51°,粒径增大到154.12 nm,最高分解温度提高到424.25 ℃,电化学分析表明,KH570具有更好的耐腐蚀性,其加入量为5%时具有较低的凝胶率。
服务
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章
张政
刘标
高延敏
关键词:  水性丙烯酸树脂  端乙烯基硅氧烷  耐腐蚀    
Abstract: Traditional solvent-based coating cause many environmental pollution problems, so it is necessary to develop new coatings with low VOC emission. Water-based acrylic resin is better environmental protection coating, because of the defects existing in acrylic resin, the preparation of waterborne need modification at the same time. Organic silicon has good performance of high and low temperature, good hydrophobicity and crosslinking, so water-based acrylic resin modified by organic silicon can make them get more excellent performance. In this work, KH570 containing vinyl siloxane was introduced into the main chain of acrylic acid to obtain modified resin, bibulous rate of the modified resin was reduced significantly, contact angle increased by 13.51°, particle size increased to 154.12 nm, maximum decomposition temperature increased to 424.25 ℃, respectively. Electrochemical analysis showed that KH570 has better corrosion resistance, and it has a lower gel rate when its content is 5%.
Key words:  waterborne acrylic resin    end-vinyl siloxane    corrosion resistance
               出版日期:  2019-05-25      发布日期:  2019-07-05
ZTFLH:  TQ633  
作者简介:  张政,2013年9月到2017年6月在山东建筑大学材料专业研究金属材料的焊接,并获得了国际焊接工程师的证书,2017年9月至今,在江苏科技大学材料科学与工程学院攻读硕士研究生,现在主要研究防腐涂料以及锂离子电池正极材料等。高延敏,江苏科技大学教授,2004年调入江苏科技大学材料科学系,现为材料学院教授,硕士研究生导师。目前担任江苏科技大学自然科学学报编委,发展规划处副处长,中国科学院腐蚀与防护研究所所长。其团队主要研究方向包括:涂料、粘合剂、油墨、复合材料、金属腐蚀与防护以及新能源电池等。主持或参与科研项目及人才计划项目若干。包括江苏省自然科学基金的缓蚀剂在涂料的缓蚀剂机理;诱导铁离子在二氧化碳腐蚀产物自矿化对基材保护机理;小分子生物矿化在铁表面的调节作用与耐腐蚀性的相关性。中船重工的LNG船超低温材料保温材料和施工工艺以及江苏省产学研项目的直接在锈层上涂装涂料设计与产业化研究等项目。已发表发明专利及期刊论文三百余篇,已培养出优秀硕士百余名。1571539864@qq.com
引用本文:    
张政, 刘标, 高延敏. 端乙烯基硅氧烷对水性丙烯酸树脂的改性[J]. 材料导报, 2019, 33(z1): 519-522.
ZHANG Zheng, LIU Biao, GAO Yanmin. Modification of Aqueous Acrylic Resin by End-vinyl Siloxane. Materials Reports, 2019, 33(z1): 519-522.
链接本文:  
http://www.mater-rep.com/CN/  或          http://www.mater-rep.com/CN/Y2019/V33/Iz1/519
1 张育波. 水分散型丙烯酸酯树脂的合成及其水性涂料的制备与性能研究. 硕士学位论文,华南理工大学,2013.
2 Park H S, Kim S R, Park H J, et al. Journal of Coatings Technology,2003,75(936),55.
3 Savaresi A. Social Science Electronic Publishing, DOI:10.3366/elr.2018.0461.
4 Zhou Jianhua,Zhang Lin, Ma Jianzhong.Journal of Macromolecular Scie-nce: Part D—Reviews in Polymer Processing,2011,50(1),15.
5 徐伟良.天津化工, 1987(3),19.
6 Gu G, Fang Y. Shanghai Coatings, 2001(1),29.
7 Wang Z F, Liu W Q, Hu C H, et al. Fine Chemicals,2010,27(3),284.
8 王宇航.中国胶粘剂,2013(1),47.
9 文秀芳. 有机硅改性丙烯酸水性树脂的合成及乳液聚合模型的研究.博士学位论文, 华南理工大学,2002.
10 Zhang L, Zhang C, Li G M. Journal of Applied Polymer Science,2007,104(2),851.
11 Kozakiewicz J, Rociszewski P, Rokicki G, et al. Surface Coatings International Part B Coatings Transactions,2001,84(4),301.
12 Park H S, Yang I M, Wu J P, et al.Journal of Applied Polymer Science, 2010,81(7),1614.
[1] 万晔, 刘晶, 谭丽丽, 陈军修, 东家慧, 杨柯. 镁粉表面钙磷涂层的制备与性能[J]. 材料导报, 2019, 33(z1): 283-287.
[2] 岳慧芳, 冯可芹, 庞华, 张瑞谦, 李垣明, 吕亮亮, 赵艳丽, 袁攀. 粉末冶金法烧结制备SiC/Zr耐事故复合材料的研究[J]. 材料导报, 2019, 33(z1): 321-325.
[3] 周治文, 江旭东, 黄朴, 陈孝阳, 韦德满, 许征兵. 高速电弧喷涂FeAlCrTiC涂层组织结构及耐磨、耐腐蚀性能[J]. 材料导报, 2019, 33(16): 2771-2776.
[4] 李小兵, 童贤靓, 杨仁贤, 刘燚栋, 万齐法, 梅路遥, 王佳铭. 电刷镀Ni-CNTs/PTFE纳米复合镀层的摩擦磨损与耐腐蚀性能[J]. 《材料导报》期刊社, 2017, 31(6): 66-71.
[5] 丁学明, 周素洪, 叶兵, 蒋海燕, 王渠东, 丁文江. 锌铜钛合金的研究进展与应用*[J]. 《材料导报》期刊社, 2017, 31(3): 38-43.
[6] 张春芝, 孔令亮, 李辉平. 镍添加对粉末冶金Al94.5Cu4Mg1.5耐腐蚀性能的提升作用*[J]. 《材料导报》期刊社, 2017, 31(20): 39-43.
[7] 高正源, 胡琳盛, 刘 浪, 任 毅, 李辉君. 从工艺参数角度探讨AZ系镁合金表面磁控溅射单层铝及氧化铝膜的耐腐蚀和耐磨损性能[J]. 材料导报, 2017, 31(1): 90-96.
[1] Bingwei LUO,Dabo LIU,Fei LUO,Ye TIAN,Dongsheng CHEN,Haitao ZHOU. Research on the Two Typical Infrared Detection Materials Serving at Low Temperatures: a Review[J]. Materials Reports, 2018, 32(3): 398 -404 .
[2] Huimin PAN,Jun FU,Qingxin ZHAO. Sulfate Attack Resistance of Concrete Subjected to Disturbance in Hardening Stage[J]. Materials Reports, 2018, 32(2): 282 -287 .
[3] Siyuan ZHOU,Jianfeng JIN,Lu WANG,Jingyi CAO,Peijun YANG. Multiscale Simulation of Geometric Effect on Onset Plasticity of Nano-scale Asperities[J]. Materials Reports, 2018, 32(2): 316 -321 .
[4] Xu LI,Ziru WANG,Li YANG,Zhendong ZHANG,Youting ZHANG,Yifan DU. Synthesis and Performance of Magnetic Oil Absorption Material with Rice Chaff Support[J]. Materials Reports, 2018, 32(2): 219 -222 .
[5] Ninghui LIANG,Peng YANG,Xinrong LIU,Yang ZHONG,Zheqi GUO. A Study on Dynamic Compressive Mechanical Properties of Multi-size Polypropylene Fiber Concrete Under High Strain Rate[J]. Materials Reports, 2018, 32(2): 288 -294 .
[6] XU Zhichao, FENG Zhongxue, SHI Qingnan, YANG Yingxiang, WANG Xiaoqi, QI Huarong. Microstructure of the LPSO Phase in Mg98.5Zn0.5Y1 Alloy Prepared by Directional Solidification and Its Effect on Electromagnetic Shielding Performance[J]. Materials Reports, 2018, 32(6): 865 -869 .
[7] ZHOU Rui, LI Lulu, XIE Dong, ZHANG Jianguo, WU Mengli. A Determining Method of Constitutive Parameters for Metal Powder Compaction Based on Modified Drucker-Prager Cap Model[J]. Materials Reports, 2018, 32(6): 1020 -1025 .
[8] WANG Tong, BAO Yan. Advances on Functional Polyacrylate/Inorganic Nanocomposite Latex for Leather Finishing[J]. Materials Reports, 2017, 31(1): 64 -71 .
[9] HUANG Dajian, MA Zonghong, MA Chenyang, WANG Xinwei. Preparation and Properties of Gelatin/Chitosan Composite Films Enhanced by Chitin Nanofiber[J]. Materials Reports, 2017, 31(8): 21 -24 .
[10] YUAN Xinjian, LI Ci, WANG Haodong, LIANG Xuebo, ZENG Dingding, XIE Chaojie. Effects of Micro-alloying of Chromium and Vanadium on Microstructure and Mechanical Properties of High Carbon Steel[J]. Materials Reports, 2017, 31(8): 76 -81 .
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed