Please wait a minute...
《材料导报》期刊社  2017, Vol. 31 Issue (12): 145-148    https://doi.org/10.11896/j.issn.1005-023X.2017.012.030
  计算模拟 |
Fe基软磁复合材料的断裂性能研究*
肖玲1, 雷忠琦1, 程文杰1, 李明1, 樊红卫1, 刘刚1, 孙岩桦2, 虞烈2
1 西安科技大学理学院, 西安710054;
2 西安交通大学机械结构强度与振动国家重点实验室, 西安 710049
Study on the Fracture Properties of Fe-based Soft Magnetic Composites
XIAO Ling1, LEI Zhongqi1, CHENG Wenjie1, LI Ming1, FAN Hongwei1, LIU Gang1, SUN Yanhua2, YU Lie2
1 Department of Basic Courses, Xi’an University of Science and Technology, Xi’an 710054;
2 State Key Laboratory for Strength and Vibration of Mechanical Structures, Xi’an Jiaotong University, Xi’an 710049
下载:  全 文 ( PDF ) ( 1727KB ) 
输出:  BibTeX | EndNote (RIS)      
摘要 基于两步热处理法进行了Fe基软磁复合材料的制备研究,成功制备出具有较高抗弯强度的软磁复合材料(SMCs),研究并分析了微观组织结构与抗弯强度的内在关系。将Fe粉表面钝化增加了Fe与具有优异介电性能的有机硅环氧树脂的结合键,提高了材料的抗弯强度,其强度达到45.3 MPa。能谱(EDS)及有限元方法(FEM)分析表明,SMCs制备中产生的孔洞及裂纹主要分布在树脂层及树脂-Fe界面,在外加载荷作用下,裂纹影响孔洞外缘的应力分布,并朝着共同断裂失效的方向扩展,故对SMCs的强度产生不利影响。为了提高SMCs的强度,需要保证树脂涂覆完整,并进一步提高树脂层本身及树脂与纯铁的粘结强度,采用热压方式减少材料中的孔洞数量。
服务
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章
肖玲
雷忠琦
程文杰
李明
樊红卫
刘刚
孙岩桦
虞烈
关键词:  软磁复合材料  有机硅环氧树脂  抗弯强度  有限元方法    
Abstract: The soft magnetic composites (SMCs) with higher flexural strength were prepared successfully by two-step heat treatment method and the relationship between the microstructure and flexural strength was investigated. The strength achieves the better value 45.3 MPa for the increase of the binding bonds between passivated iron powders and organosilicon epoxy resin (OER) with excellent dielectric properties. Energy dispersion spectrum (EDS) and finite element method (FEM) results showed that the pores and cracks produced during the SMCs preparation process were mainly distributed in the resin layer and resin-Fe interface. Under the external load, the stress distribution of the pore edge was affected by the crack, and made them expand toward the same fai-lure direction, resulting in a negative effect on the strength of SMCs. Our work suggests that the improve of the SMCs′ strength depends on the integrity of the coating resin, the further enhancement of resin/iron adhesive strength and resin layer′s strength, as well as the use of hot pressing to reduce pores.
Key words:  soft magnetic composites    organosilicon epoxy resin    flexural strength    finite element method
               出版日期:  2017-06-25      发布日期:  2018-05-08
ZTFLH:  TH142.2  
基金资助: *国家自然科学基金(11502196);中国博士后资助项目(2015M580865);陕西省教育厅资助项目(15JK1483);陕西省博士后资助项目(2016BSHEDZZ77)
作者简介:  肖玲:女,1983年生,博士,讲师,研究方向为电磁推力轴承(MTB)的涡流及动态特性分析、MTB用软磁复合材料(SMCs)的开发研究、弹性箔片气体轴承(GFB)承载力和起停时的润滑研究 E-mail:xiaoling@xust.edu.cn
引用本文:    
肖玲, 雷忠琦, 程文杰, 李明, 樊红卫, 刘刚, 孙岩桦, 虞烈. Fe基软磁复合材料的断裂性能研究*[J]. 《材料导报》期刊社, 2017, 31(12): 145-148.
XIAO Ling, LEI Zhongqi, CHENG Wenjie, LI Ming, FAN Hongwei, LIU Gang, SUN Yanhua, YU Lie. Study on the Fracture Properties of Fe-based Soft Magnetic Composites. Materials Reports, 2017, 31(12): 145-148.
链接本文:  
http://www.mater-rep.com/CN/10.11896/j.issn.1005-023X.2017.012.030  或          http://www.mater-rep.com/CN/Y2017/V31/I12/145
1 Xiao L, Sun Y H, Ding C H, et al. Influence of the component size ratio on densification and magnetic property of soft magnetic compo-sites [J]. Int J Appl Electromag Mechan,2012,39(1-4):548.
2 Xiao L, Sun Y H, Ding C H, et al. Annealing effects on magnetic properties and strength of organic-silicon epoxy resin-coated soft magnetic composites[J]. Proceedings of the Institution of Mechanical Engineers,2014,228(12):2050.
3 Shokrollahi H, Janghorban K. Effect of warm compaction on the magnetic and electrical properties of Fe-based soft magnetic compo-sites[J]. J Magn Magn Mater,2007,313(1):182.
4 Hamler A, Gorican V, Sustarsic B,et al. The use of soft magnetic composite materials in synchronous electric motor [J]. J Magn Magn Mater,2006,304(2):816.
5 Hultman L O, Jack A G. Soft magnetic composites materials and applications [C]// Proceedings of the IEEE International Electric Machines and Drives Conference.2003.
6 Taghvaei A, Shokrollahi H, Ebrahimi A, et al. Soft magnetic composites of iron-phenolic and the influence of silane coupling agent on the magnetic properties[J].Mater Chem Phys,2009,116(1):247.
7 Koohkan R, Sharafi S, Shokrollahi H, et al. Preparation of nanocrystalline Fe-Ni powders by mechanical alloying used in soft magnetic composites[J].J Magn Magn Mater,2008,320(6):1089.
8 Shokrollahi H, Janghorban K, Mazaleyrat F, et al. Investigation of magnetic properties, residual stress and densification in compacted iron powder specimens coated with polyepoxy [J]. Mater Chem Phys,2009,114(2):588.
9 Cui Y, Kliman G. Modeling of soft magnetic composites[C]//39th IAS Annual Meeting,IEEE,2004.
10 Ding D H, Li Y W, Hao H Q,et al. Grey equation between bending strength and porosity of copper-graphic composite[J]. Chin J Nonferrous Metals,1996,6(4):123(in Chinese).
丁华东, 李雅文, 浩宏奇,等.铜石墨材料抗弯强度与孔隙的关系[J].中国有色金属学报,1996,6(4):123.
11 Xiao L, Li M, Cheng W J, et al. Influence of annealing methods on the magnetic properties and flexural strength of Iron-OER soft magnetic composites[J]. Adv Mater Sci Eng:DOI:10.1155/2016/5378276.
[1] 李旺昌, 王兆佳, 李晶鑫, 车声雷. 用于高频电机磁芯的金属软磁复合材料研究进展[J]. 《材料导报》期刊社, 2018, 32(7): 1139-1144.
[2] 钟汝能, 郑勤红, 向泰, 姚斌. 颗粒填充二元复合材料等效介电特性的修正通用有效介质计算公式[J]. 材料导报, 2018, 32(24): 4258-4263.
[3] 刘发齐, 关志东, 边天涯. 三维编织复合材料紧固件剪切强度预报[J]. 《材料导报》期刊社, 2017, 31(7): 121-128.
[1] Bingwei LUO,Dabo LIU,Fei LUO,Ye TIAN,Dongsheng CHEN,Haitao ZHOU. Research on the Two Typical Infrared Detection Materials Serving at Low Temperatures: a Review[J]. Materials Reports, 2018, 32(3): 398 -404 .
[2] Huimin PAN,Jun FU,Qingxin ZHAO. Sulfate Attack Resistance of Concrete Subjected to Disturbance in Hardening Stage[J]. Materials Reports, 2018, 32(2): 282 -287 .
[3] Siyuan ZHOU,Jianfeng JIN,Lu WANG,Jingyi CAO,Peijun YANG. Multiscale Simulation of Geometric Effect on Onset Plasticity of Nano-scale Asperities[J]. Materials Reports, 2018, 32(2): 316 -321 .
[4] Xu LI,Ziru WANG,Li YANG,Zhendong ZHANG,Youting ZHANG,Yifan DU. Synthesis and Performance of Magnetic Oil Absorption Material with Rice Chaff Support[J]. Materials Reports, 2018, 32(2): 219 -222 .
[5] Ninghui LIANG,Peng YANG,Xinrong LIU,Yang ZHONG,Zheqi GUO. A Study on Dynamic Compressive Mechanical Properties of Multi-size Polypropylene Fiber Concrete Under High Strain Rate[J]. Materials Reports, 2018, 32(2): 288 -294 .
[6] XU Zhichao, FENG Zhongxue, SHI Qingnan, YANG Yingxiang, WANG Xiaoqi, QI Huarong. Microstructure of the LPSO Phase in Mg98.5Zn0.5Y1 Alloy Prepared by Directional Solidification and Its Effect on Electromagnetic Shielding Performance[J]. Materials Reports, 2018, 32(6): 865 -869 .
[7] ZHOU Rui, LI Lulu, XIE Dong, ZHANG Jianguo, WU Mengli. A Determining Method of Constitutive Parameters for Metal Powder Compaction Based on Modified Drucker-Prager Cap Model[J]. Materials Reports, 2018, 32(6): 1020 -1025 .
[8] WANG Tong, BAO Yan. Advances on Functional Polyacrylate/Inorganic Nanocomposite Latex for Leather Finishing[J]. Materials Reports, 2017, 31(1): 64 -71 .
[9] HUANG Dajian, MA Zonghong, MA Chenyang, WANG Xinwei. Preparation and Properties of Gelatin/Chitosan Composite Films Enhanced by Chitin Nanofiber[J]. Materials Reports, 2017, 31(8): 21 -24 .
[10] YUAN Xinjian, LI Ci, WANG Haodong, LIANG Xuebo, ZENG Dingding, XIE Chaojie. Effects of Micro-alloying of Chromium and Vanadium on Microstructure and Mechanical Properties of High Carbon Steel[J]. Materials Reports, 2017, 31(8): 76 -81 .
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed