Abstract: Mullite precursor powders were prepared by a sol-gel method by using aluminum nitrate nonahydrate and ethyl orthosilicate as raw materials, as pH value of reaction solution is about 8. The effect of cobalt oxide addition on the phase compositions and densification of mullite cera-mics obtained by sintering of mullite precursor were investigated. The results show that the formation temperature of mullite was significantly reduced, and it was about 100 ℃ lower than that of the sample without cobalt oxide addition. The sinterability of mullite precursors prepared by sol-gel method shows that the densification rate of the sample with cobalt oxide is faster than that of the sample without cobalt oxide. The maximum bulk density of the sample can reach to 2.912 g/cm3, as the mullite precursors with 10wt% cobalt oxide addition were sintered at the temperature of 1 400 ℃ for 2 h. And a large number of needle-like mullite grains with the ratio of length to diameter of ~14 were obtained in the sample. Needle-like mullite grains interweave with each other to form a dense network structure. The effect of cobalt oxide addition on the phase compositions and densification behavior of mullite ceramics maybe attributed to Al3+ in mullite [AlO6] octahedron structure may be replaced by Co2+, which cause its grain lattice distortion and activate its grain lattice. And mullite was formed and sintered at the lower sintering temperature.
1 Zhu J B, Yan H. International Journal of Minerals, Metallurgy and Materials, 2017, 24, 309. 2 Ye H, Li Y, Sun J. Ceramics International, 2019, 45, 12934. 3 Schneider H, Schreuer J, Hildmann B. Journal of the European Ceramic Society, 2008, 28, 329. 4 Joaquin A S, Heberto B R, Richard C, et al. Journal of Ceramic Proce-ssing Research, 2007, 8(1), 1. 5 Lin B, Li S P, Hou X J, et al.Journal of Alloys and Compounds, 2015, 623, 359. 6 Hartmut Schneider, Reinhard X Fischer, et al.Journal of the American Ceramic Society, 2015, 98(10), 2948. 7 Gao H, Luo F, Wen Q L, et al. Ceramics International, 2019, 45, 11625. 8 Li W, Zhang J, Li X C, et al.Ceramics International, 2019, 45, 17325. 9 Liu Y, Lian W, Su W F, et al.Applied Ceramic Technology, 2020, 17, 205. 10 Ye H, Li Y, Sun J L, et al.Ceramics International, 2019, 45, 4680. 11 Deng X G, Zhang W C, Yin J Q, et al.Ceramics International, 2020, 46, 8438. 12 Liang L, Li J B, Lin H, et al.Chinese Journal of Aeronautics, 2006, 19, 71. 13 Yang M M, Luo X D, Yi J, et al.Ceramics International, 2018, 44, 12664. 14 Su W F, Liu Y, Song H X, et al.China Powder Science and Technology, 2018, 24(4), 28(in Chinese). 苏万福, 刘银, 宋瀚轩, 等.中国粉体技术, 2018, 24(4), 28. 15 Wang W, Li H W, Lai K R. et al. Journal of Alloys and Compounds, 2012, 510, 92. 16 Debasis R, Kumaresh H, Biplab K P, et al.Journal of Surface Engineered Materials and Advanced Technology, 2013, 3, 11. 17 Xu S H, Wang Y C, Fu Z Y, et al.Journal of Wuhan University of Technology, 2010, 32(2), 4(in Chinese). 许少华, 王玉成, 傅正义, 等.武汉理工大学学报, 2010, 32(2), 4. 18 Wang Y, Liu H T, Cheng H F, et al.Rare Metal Materials and Enginee-ring, 2016, 45(s1), 171. 19 Li H Z, Li Z J, Luo X D, et al.Materials Review, 2016, 30(S2), 452(in Chinese). 李和桢, 李志坚, 罗旭东, 等.材料导报, 2016, 30(专辑28), 452. 20 Wu J, Lin H, Li J B, et al.Journal of Inorganic Materials, 2009, 24(5), 1077(in Chinese). 吴疆, 林红, 李建保, 等.无机材料学报, 2009, 24(5), 1077. 21 Yan M W, Li Y, Chen J H, et al.Journal of the Chinese Ceramic Society, 2016, 44(12), 1792(in Chinese). 闫明伟, 李勇, 陈俊红, 等.硅酸盐学报, 2016, 44(12), 1792. 22 Khattab R M, Sadek H E H, Abo-almaged H H.Silicon, 2017, 10, 1487. 23 Zhang J H, Ke C M, Wu H D, et al.Rare Metal Materials and Enginee-ring, 2015, 44(2), 0323. 24 Viswabaskaran V, Gnanam F D, Balasubramanian M.Journal of Materials Processing Technology, 2003, 142, 275.
渝公网安备50019002502923号 版权所有：《材料导报》编辑部
2020, Vol. 34 
