Please wait a minute...
材料导报  2020, Vol. 34 Issue (Z2): 437-440    
  金属与金属基复合材料 |
690合金在核电厂一、二回路工况下的均匀腐蚀性能研究
林震霞, 党莹, 徐祺, 李丹
中国核动力研究设计院,成都 610213
Research on General Corrosion of Alloy 690 in Primary and Secondary Loops of Nuclear Plants
LIN Zhenxia, DANG Ying, XU Qi, LI Dan
Nuclear Power Institute of China, Chengdu 610213, China
下载:  全 文 ( PDF ) ( 4493KB ) 
输出:  BibTeX | EndNote (RIS)      
摘要 690合金是当前核电厂应用最广泛的蒸汽发生器传热管材料。传热管的破损主要是由腐蚀造成,因此有必要对690合金在核电厂工况下的耐腐蚀性能进行研究。当前对690合金的均匀腐蚀实验方法可以实现对温度、压力、介质化学成分的控制,但未考虑流质冲刷的影响。蒸汽发生器传热管在实际服役时,其一、二次侧接触的介质是高速流动的,高速流质冲刷很可能对均匀腐蚀具有促进作用。本实验通过新开发的一套搅拌装置,首次实现对介质流速的实验控制。在模拟核电厂一、二回路工况下,精确控制回路水化学和介质流速,获得了国产690合金的均匀腐蚀速率和金属腐蚀产物释放速率,并与进口同规格管材作对比,评价其耐均匀腐蚀性能。结果表明,国产690合金传热管的耐均匀腐蚀性能与进口材料基本相当;流质冲刷对690合金传热管一次侧均匀腐蚀具有一定的促进作用,而对二次侧均匀腐蚀没有明显的促进作用。
服务
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章
林震霞
党莹
徐祺
李丹
关键词:  690合金  传热管  均匀腐蚀  冲刷腐蚀  流速    
Abstract: Alloy 690 is the most widely used material for steam generator (SG) heat transfer tubes of nuclear power plants. The failure of heat transfer tubes is caused mainly by corrosion. So it’s necessary to study the corrosion resistance of alloy 690 in nuclear power plant. The current experiment on general corrosion of alloy 690 can control the parameters of temperature, pressure and chemical component, but not yet consider the influence of flow. Actually, the primary and secondary water in contact with SG tubes flows at high speed, and the flow possibly has some promoting effect on general corrosion. The experimental method of this paper can control the flow rate for the first time by means of a newly developed set of agitation equipment.The experiments of general corrosion in this paper are conducted in simulated primary and secondary loops of nuclear plants, to acquire the corrosion rate and the metal corrosion product release rate of domestic alloy 690 tubes, which are compared with tubes from Valinox. In the experiments, water chemistry and flow rate are controlled accurately. The results indicate that, the general corrosion resistance of domestic alloy 690 tubes is almost equal to the imported tubes; erosion has some effect on primary general corrosion of alloy 690, but has no obvious effect on secondary general corrosion.
Key words:  alloy 690    heat transfer tube    general corrosion    erosion corrosion    flow rate
               出版日期:  2020-11-25      发布日期:  2021-01-08
ZTFLH:  TL341  
通讯作者:  836669432@qq.com   
作者简介:  林震霞,中国核动力研究设计院助理研究员;2014年6月毕业于中国核动力研究设计院,获得硕士学位,现主要从事反应堆结构材料研究工作。
引用本文:    
林震霞, 党莹, 徐祺, 李丹. 690合金在核电厂一、二回路工况下的均匀腐蚀性能研究[J]. 材料导报, 2020, 34(Z2): 437-440.
LIN Zhenxia, DANG Ying, XU Qi, LI Dan. Research on General Corrosion of Alloy 690 in Primary and Secondary Loops of Nuclear Plants. Materials Reports, 2020, 34(Z2): 437-440.
链接本文:  
http://www.mater-rep.com/CN/  或          http://www.mater-rep.com/CN/Y2020/V34/IZ2/437
1 Dutta R S.Journal of Nuclear Materials, 2009, 393, 343.
2 朱娟, 张乔斌, 陈宇, 等. 中国腐蚀与防护学报, 2014, 34(3), 99.
3 李强, 唐晓, 李焰.中国腐蚀与防护学报, 2014, 34(5), 399.
4 党莹, 林震霞, 潘小强, 等. 核动力工程, 2016, 37(3), 61.
5 吴成红, 甘复兴. 材料保护, 2000, 33(4), 33.
[1] 鞠娜, 雷玉成, 陈钢, 朱强, 李天庆, 王丹. 410不锈钢在550 ℃流动的铅铋共晶合金中的腐蚀行为[J]. 材料导报, 2019, 33(20): 3489-3493.
[1] Ninghui LIANG,Peng YANG,Xinrong LIU,Yang ZHONG,Zheqi GUO. A Study on Dynamic Compressive Mechanical Properties of Multi-size Polypropylene Fiber Concrete Under High Strain Rate[J]. Materials Reports, 2018, 32(2): 288 -294 .
[2] WANG Tong, BAO Yan. Advances on Functional Polyacrylate/Inorganic Nanocomposite Latex for Leather Finishing[J]. Materials Reports, 2017, 31(1): 64 -71 .
[3] GUO Hongjian, JIA Junhong, ZHANG Zhenyu, LIANG Bunu, CHEN Wenyuan, LI Bo, WANG Jianyi. Microstructure and Tribological Properties of VN/Ag Films Fabricated by Pulsed Laser Deposition Technique[J]. Materials Reports, 2017, 31(2): 55 -59 .
[4] WANG Wenjin, WANG Keqiang, YE Shenjie, MIAO Weijun, CHEN Zhongren. Effect of Asymmetric Block Copolymer of PI-b-PB on Phase Morphology and Properties of IR/BR Blends[J]. Materials Reports, 2017, 31(2): 96 -100 .
[5] HUANG Dajian, MA Zonghong, MA Chenyang, WANG Xinwei. Preparation and Properties of Gelatin/Chitosan Composite Films Enhanced by Chitin Nanofiber[J]. Materials Reports, 2017, 31(8): 21 -24 .
[6] YUAN Xinjian, LI Ci, WANG Haodong, LIANG Xuebo, ZENG Dingding, XIE Chaojie. Effects of Micro-alloying of Chromium and Vanadium on Microstructure and Mechanical Properties of High Carbon Steel[J]. Materials Reports, 2017, 31(8): 76 -81 .
[7] ZHANG Le, ZHOU Tianyuan, CHEN Hao, YANG Hao, ZHANG Qitu, SONG Bo, WONG Chingping. Advances in Transparent Nd∶YAG Laser Ceramics[J]. Materials Reports, 2017, 31(13): 41 -50 .
[8] YAN Zhilong, LI Yongsheng, HU Kai, ZHOU Xiaorong. Progress of Study on Phase Decomposition of Duplex Stainless Steel[J]. Materials Reports, 2017, 31(15): 75 -80 .
[9] SHI Yu, ZHOU Xianglong, ZHU Ming, GU Yufen, FAN Ding. Effect of Filler Wires on Brazing Interface Microstructure and Mechanical Properties of Al/Cu Dissimilar Metals Welding-Brazing Joint[J]. Materials Reports, 2017, 31(10): 61 .
[10] DONG Fei,YI Youping,HUANG Shiquan,ZHANG Yuxun,. TTT Curves and Quench Sensitivity of 2A14 Aluminum Alloy[J]. Materials Reports, 2017, 31(10): 77 -81 .
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed