Please wait a minute...
《材料导报》期刊社  2017, Vol. 31 Issue (16): 138-143    https://doi.org/10.11896/j.issn.1005-023X.2017.016.029
  计算模拟 |
焰熔法生长钛酸锶单晶体生长室内温度分布的数值模拟*
刘旭东1, 毕孝国2, 孙旭东1,3
1 大连大学环境与化学工程学院, 大连 116622;
2 沈阳工程学院新能源学院, 沈阳 110136;
3 东北大学材料科学与工程学院, 沈阳 110819
Numerical Simulation of Temperature Distribution in Growth Chamber for Preparation of Strontium Titanate Crystal with Flame Fusion Method
LIU Xudong1, BI Xiaoguo2, SUN Xudong1,3
1 College of Environmental and Chemical Engineering, Dalian University, Dalian 116622;
2 School of New Energy, Shenyang Institute of Engineering, Shenyang 110136;
3 School of Materials Science and Engineering, Northeastern University, Shenyang 110819
下载:  全 文 ( PDF ) ( 1937KB ) 
输出:  BibTeX | EndNote (RIS)      
摘要 通过研究焰熔法生长钛酸锶单晶体过程中生长室内的温度分布特征,分析了H2和O2流量、喷嘴孔径对温度分布的影响。结果表明,采用焰熔法生长SrTiO3晶体时,晶体熔帽表面温度和压力由中心逐渐向外降低;随着H2流量的增加,中心轴向的最高温度的位置基本不变,晶体熔帽温度和晶体四周的最高温度逐渐升高,只是升高幅度有所减小;晶体熔帽温度、压力及晶体周围烟气温度随O2流量增大而升高,而轴向最高温度则降低;增加喷嘴的中心孔径将使轴向最高温度、晶体熔帽温度和径向温度梯度降低,而喷嘴的H2孔径对生长室内轴向和径向温度分布的影响不是很明显。
服务
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章
刘旭东
毕孝国
孙旭东
关键词:  焰熔法  钛酸锶单晶体  生长室  温度分布    
Abstract: Temperature distribution in growth chamber for preparation of strontium titanate single crystal with hydro-oxygen flame fusion method was investigated, and the effects of oxygen and hydrogen flow rate and aperture of nozzle on temperature distribution was analyzed. The results showed that the radial temperature and pressure at growth position of crystal decreased with the increasing of diameter. The maximal axial temperature and radial temperature of the melted cap of crystal increased with the increasing of hydrogen flow rate. With the increasing of oxygen flow rate, the radial temperature and pressure of the melted cap of crystal increased gradually in the growth chamber, while the maximal axial temperature decreased. With the increasing of oxygen aperture, the maximal axial temperature, the radial temperature and gradient decreased. The aperture of hydrogen had little effect on the axial and radial temperature in growth chamber.
Key words:  flame fusion method    strontium titanate single crystal    growth chamber    temperature distribution
               出版日期:  2017-08-25      发布日期:  2018-05-07
ZTFLH:  TB321  
  O782  
基金资助: 国家自然科学基金(51472047)
作者简介:  刘旭东:男,1975年生,副教授,研究方向为特种功能光学晶体材料 E-mail:liuxd@sie.edu.cn
引用本文:    
刘旭东, 毕孝国, 孙旭东. 焰熔法生长钛酸锶单晶体生长室内温度分布的数值模拟*[J]. 《材料导报》期刊社, 2017, 31(16): 138-143.
LIU Xudong, BI Xiaoguo, SUN Xudong. Numerical Simulation of Temperature Distribution in Growth Chamber for Preparation of Strontium Titanate Crystal with Flame Fusion Method. Materials Reports, 2017, 31(16): 138-143.
链接本文:  
http://www.mater-rep.com/CN/10.11896/j.issn.1005-023X.2017.016.029  或          http://www.mater-rep.com/CN/Y2017/V31/I16/138
1 Joseph A Adamski. New oxy-hydrogen burner for flame fusion[J].J Appl Phys,1965,36(5):1784.
2 Khambatta F B, et al. Initial thermal model of the flame fusion crsystal growth process[J].J Cryst Growth,1972,13:710.
3 Hans J Scheel.Historical aspects of crystal growth technology[J].J Cryst Growth,2000,211:1.
4 Liu Xudong, Bi Xiaoguo, Tang Jian, et al. Numerical simulation of the influence of growth parameters on the temperature distribution in growth chamber[J]. Mater Sci Technol,2015,23(6):57(in Chinese).
刘旭东,毕孝国,唐坚,等. 生长工艺对生长室内温度分布影响的数值模拟[J]. 材料科学与工艺,2015,23(6):57.
5 Liu Xudong, Bi Xiaoguo, Tang Jian, et al. Study on combustion characteristic in growth chamber for preparation of single crystal with flame fusion method[J]. Chinese J Mater Res,2015,29(5):394(in Chinese).
刘旭东, 毕孝国, 唐坚, 等. 焰熔法制备单晶体生长室内的燃烧特性[J].材料研究学报,2015,29(5):394.
6 Liu Xudong, Bi Xiaoguo, Tang Jian, et al. Study on temperature distribution in combustion chamber for preparation of single crystal with flame fusion method[J]. J Shenyang Institute of Engineering:Nat Sci,2014(4):378(in Chinese).
刘旭东,毕孝国,唐坚,等.焰熔法生长单晶体燃烧室内温度分布研究[J].沈阳工程学院学报:自然科学版,2014(4):378.
7 Bi Xiaoguo, Xiu Zhimeng, Ma Weimin, et al. Study on effect of growth atmosphere and rate on preparation of rutile (TiO2) single crystal[J]. J Synthetic Crystals,2004,33(4):657(in Chinese).
毕孝国, 修稚萌, 马伟民, 等. 生长气氛和速度在金红石(TiO2)单晶体生长中的作用研究[J]. 人工晶体学报,2004,33(4):657.
8 Bi Xiaoguo, Xiu Zhimeng, Sun Xudong, et al.Experimental study on growth conditions of big-bulk rutile crystal[J].J Synthetic Crystals,2004,33(2):244(in Chinese).
毕孝国, 修稚萌, 孙旭东, 等. 大尺寸金红石(TiO2)单晶体生长条件的实验研究[J].人工晶体学报,2004,33(2):244.
9 Bi Xiaoguo, Xiu Zhimeng, Ma Weimin, et al. Study on growth of rutile (TiO2) single crystals[J]. J Northeastern University:Nat Sci,2004,25(10):977(in Chinese).
毕孝国, 修稚萌, 马伟民, 等. 金红石(TiO2)单晶体的生长研究[J]. 东北大学学报,2004,25(10):977.
10 Scheel H J. Crystal growth technology CGT for energy: Saving energy and renewable energy[J]. J Cryst Growth,2005,275:331.
11 Donnet J B, Oulanti H,et al. Sythesis of large crystal diamond using combustion-flame method[J].Carbon,2006,44(2):374.
12 Bi Xiaoguo, Liu Xudong, Niu Wei. Flame-fusion growth of rutile single crystal[J].Adv Mater Res,2012,535-537:2571.
[1] 毛育青,柯黎明,陈玉华,刘奋成. 铝合金厚板搅拌摩擦焊焊缝局部金属的塑性流动特征[J]. 《材料导报》期刊社, 2017, 31(24): 145-149.
[1] Bingwei LUO,Dabo LIU,Fei LUO,Ye TIAN,Dongsheng CHEN,Haitao ZHOU. Research on the Two Typical Infrared Detection Materials Serving at Low Temperatures: a Review[J]. Materials Reports, 2018, 32(3): 398 -404 .
[2] Huimin PAN,Jun FU,Qingxin ZHAO. Sulfate Attack Resistance of Concrete Subjected to Disturbance in Hardening Stage[J]. Materials Reports, 2018, 32(2): 282 -287 .
[3] Siyuan ZHOU,Jianfeng JIN,Lu WANG,Jingyi CAO,Peijun YANG. Multiscale Simulation of Geometric Effect on Onset Plasticity of Nano-scale Asperities[J]. Materials Reports, 2018, 32(2): 316 -321 .
[4] Xu LI,Ziru WANG,Li YANG,Zhendong ZHANG,Youting ZHANG,Yifan DU. Synthesis and Performance of Magnetic Oil Absorption Material with Rice Chaff Support[J]. Materials Reports, 2018, 32(2): 219 -222 .
[5] Ninghui LIANG,Peng YANG,Xinrong LIU,Yang ZHONG,Zheqi GUO. A Study on Dynamic Compressive Mechanical Properties of Multi-size Polypropylene Fiber Concrete Under High Strain Rate[J]. Materials Reports, 2018, 32(2): 288 -294 .
[6] XU Zhichao, FENG Zhongxue, SHI Qingnan, YANG Yingxiang, WANG Xiaoqi, QI Huarong. Microstructure of the LPSO Phase in Mg98.5Zn0.5Y1 Alloy Prepared by Directional Solidification and Its Effect on Electromagnetic Shielding Performance[J]. Materials Reports, 2018, 32(6): 865 -869 .
[7] ZHOU Rui, LI Lulu, XIE Dong, ZHANG Jianguo, WU Mengli. A Determining Method of Constitutive Parameters for Metal Powder Compaction Based on Modified Drucker-Prager Cap Model[J]. Materials Reports, 2018, 32(6): 1020 -1025 .
[8] WANG Tong, BAO Yan. Advances on Functional Polyacrylate/Inorganic Nanocomposite Latex for Leather Finishing[J]. Materials Reports, 2017, 31(1): 64 -71 .
[9] HUANG Dajian, MA Zonghong, MA Chenyang, WANG Xinwei. Preparation and Properties of Gelatin/Chitosan Composite Films Enhanced by Chitin Nanofiber[J]. Materials Reports, 2017, 31(8): 21 -24 .
[10] YUAN Xinjian, LI Ci, WANG Haodong, LIANG Xuebo, ZENG Dingding, XIE Chaojie. Effects of Micro-alloying of Chromium and Vanadium on Microstructure and Mechanical Properties of High Carbon Steel[J]. Materials Reports, 2017, 31(8): 76 -81 .
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed