Please wait a minute...
《材料导报》期刊社  2017, Vol. 31 Issue (2): 33-36    https://doi.org/10.11896/j.issn.1005-023X.2017.02.007
  材料研究 |
二次烧结气氛对La0.7Sr0.3MnO3氧还原催化活性的影响*
汪广进1,2, 程凡1, 徐甜2, 余意2, 文胜1, 龚春丽1, 刘海1, 汪杰1, 郑根稳1, 潘牧2
1 湖北工程学院化学与材料科学学院, 孝感 432000;
2 武汉理工大学材料复合新技术国家重点实验室,湖北燃料电池重点实验室, 武汉 430070;
Effect of Secondary Sintering Atmosphere on the Catalytic Activity of La0.7Sr0.3MnO3 for Oxygen Reduction
WANG Guangjin1,2, CHENG Fan1, XU Tian2, YU Yi2, WEN Sheng1, GONG Chunli1,
LIU Hai1, WANG Jie1, ZHENG Genwen1, PAN Mu2
1 College of Chemistry and Materials Science, Hubei Engineering University, Xiaogan 432000;
2 State Key Laboratory of Advanced Technology for Materials Synthesis and Processing, Hubei Provincial Key Laboratory of Fuel Cell, Wuhan University of Technology, Wuhan 430070;
下载:  全 文 ( PDF ) ( 1544KB ) 
输出:  BibTeX | EndNote (RIS)      
摘要 采用溶胶-凝胶法结合二次高温烧结技术,制备了锰系钙钛矿催化剂。利用XRD和EDS对催化剂的物相与元素组成进行了分析,并利用电化学分析方法研究了催化剂的氧还原催化性能。XRD与EDS结果表明,N2气氛二次烧结不改变La0.7Sr0.3-MnO3物相组成,但NH3气氛二次烧结会造成La0.7Sr0.3MnO3分解。电化学结果表明,N2气氛二次烧结催化剂的氧还原催化活性高于NH3气氛二次烧结催化剂,其氧还原起始电势与极限电流分别为0.028 V (vs. Hg/HgO)和2.181 mA·cm-2(2 000 r/min)。
服务
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章
汪广进
程凡
徐甜
余意
文胜
龚春丽
刘海
汪杰
郑根稳
潘牧
关键词:  二次烧结  La0.7Sr0.3MnO3  氧还原反应  催化活性    
Abstract: Herein, manganese-based pervoskite oxide was prepared by a sol-gel method combined with secondary sintering technology, and then characterized by means of XRD and EDS to analyze its phase and element composition, electrochemical measurement to investigate its catalytic activity for oxygen reduction reaction. XRD and EDS results showed that the phase of La0.7Sr0.3MnO3 remained intact after secondary sintering treatment under N2 atmosphere, while was destroyed under NH3 atmosphere. The electrochemical results showed that the catalytic activity of the catalyst prepared under N2 atmosphere for oxygen reduction reaction is hi-gher than that of catalyst prepared under NH3 atmosphere. The onset potential for oxygen reduction and limited current density are 0.028 V (vs. Hg/HgO) and 2.181 mA·cm-2 (2 000 r/mim), respectively.
Key words:  secondary sintering treatment    La0.7Sr0.3MnO3    oxygen reduction reaction    catalytic activity
               出版日期:  2017-01-25      发布日期:  2018-05-02
ZTFLH:  TM911.4  
基金资助: *国家自然科学基金(21476178);教育部博士基金(20130143130001);湖北省自然科学基金(2015CFC769)
作者简介:  汪广进:男,1985年生,博士,讲师,从事新能源材料研究 E-mail:wgj501@163.com 程凡:通讯作者,女,1983年生,硕士,讲师,从事新能源材料研究 E-mail:fanfan94555@sina.com 潘牧:通讯作者,男,1965年生,博士,教授,博士研究生导师,从事新能源材料研究 E-mail:panmu@whut.edu.cn
引用本文:    
汪广进, 程凡, 徐甜, 余意, 文胜, 龚春丽, 刘海, 汪杰, 郑根稳, 潘牧. 二次烧结气氛对La0.7Sr0.3MnO3氧还原催化活性的影响*[J]. 《材料导报》期刊社, 2017, 31(2): 33-36.
WANG Guangjin, CHENG Fan, XU Tian, YU Yi, WEN Sheng, GONG Chunli,
LIU Hai, WANG Jie, ZHENG Genwen, PAN Mu. Effect of Secondary Sintering Atmosphere on the Catalytic Activity of La0.7Sr0.3MnO3 for Oxygen Reduction. Materials Reports, 2017, 31(2): 33-36.
链接本文:  
http://www.mater-rep.com/CN/10.11896/j.issn.1005-023X.2017.02.007  或          http://www.mater-rep.com/CN/Y2017/V31/I2/33
1 Yu Y, Li H, Wang H, et al. A review on performance degradation of proton exchange membrane fuel cells during startup and shutdown processes: Causes, consequences, and mitigation strategies [J]. J Power Sources,2012,205:10.
2 NØrskov J K, Rossmeisl J, Logadottir A, et al. Origin of the overpotential for oxygen reduction at a fuel-cell cathode [J]. J Phys Chem B,2004,108(46):17886.
3 Fernandes A C, Paganin V A, Ticianelli E A. Degradation study of Pt-based alloy catalysts for the oxygen reduction reaction in proton exchange membrane fuel cells [J]. J Electroanalytical Chem,2010,648(2):156.
4 Miyazaki K, Sugimura N, Matsuoka K, et al. Perovskite-type oxi-des La1- xSrxMnO3 for cathode catalysts in direct ethylene glycol alkaline fuel cells [J]. J Power Sources,2008,178(2):683.
5 Li D, Li S, Pan M. Study on the catalytic activity of perovskite-type oxide La0.65Sr0.3MnO3 for oxygen reduction [J]. J Hubei University: Nat Sci Ed,2011,33(1):99(in Chinese).
李丹林,李赏,潘牧.钙钛矿型氧化物 La0.65Sr0.3MnO3对氧还原的催化活性研究 [J]. 湖北大学学报:自然科学版,2011,33(1):99.
6 Xu T, Wang G, Yu Y, et al. Study on the electrochemical and kinetic characteristics of La0.7Sr0.3MnO3 [J]. Chinese Battery Ind,2012,17(6):365(in Chinese).
徐甜,汪广进,余意,等.La0.7Sr0.3MnO3 电化学特征及氧还原动力学研究 [J].电池工业,2012,17(6):365.
7 Wang G, Xu T, Wen S, et al. Structure-dependent electrocatalytic activity of La1-xSrxMnO3 for oxygen reduction reaction [J]. Sci China Chem,2015,58(5):871.
8 Suntivich J, Gasteiger H A, Yabuuchi N, et al. Design principles for oxygen-reduction activity on perovskite oxide catalysts for fuel cells and metal-air batteries [J]. Nat Chem,2011,3(7):546.
9 Wang Y, Cheng H P. Oxygen reduction activity on perovskite oxide surfaces: A comparative first-principles study of LaMnO3, LaFeO3, and LaCrO3 [J]. J Phys Chem C,2013,117(5):2106.
10 Tulloch J, Donne S W. Activity of perovskite La1-xSrxMnO3 catalysts towards oxygen reduction in alkaline electrolytes [J]. J Power Sources,2009,188(2):359.
11 Xu T, Wang G, Liang C, et al. N-doped La2Zr2O7 as an enhanced electrocatalyst for oxygen reduction reaction [J]. Electrochimica Acta,2014,143:83.
12 Atsumi T, Kamegashira N. Decomposition oxygen partial pressures of Ln1-xSrxMnO3 (Ln= La, Nd and Dy) [J]. J Alloys Compd,1997,257(1):161.
13 Andrieux M, Picard C. Nonstoichiometry and phase stability of La0.8Sr0.2MnOδ at 1273 K [J]. J Mater Sci Lett,2000,19(8):695.
[1] 王丽丽, 姚建省, 许亮, 杨小薇, 顾国红, 李鑫, 牛书鑫. 熔融石英球形粉对陶瓷型芯高温收缩的影响[J]. 材料导报, 2019, 33(14): 2311-2314.
[2] 李雅明, 李艳军, 张江, 丛野, 崔正威, 袁观明, 董志军, 邹涛, 李轩科. K3V5O14的合成及光催化性能和吸附性能[J]. 材料导报, 2019, 33(12): 1926-1931.
[3] 郝佳瑜, 刘易斯, 李文章, 李洁. 形貌可控的铂类贵金属氧还原电催化剂研究进展[J]. 材料导报, 2019, 33(1): 127-134.
[4] 夏艺萌, 吴帅, 谭丰, 李卫, 魏清茂, 闵春刚, 杨喜昆. 钴盐阴离子基团对Co-N-C催化剂电催化活性的影响[J]. 《材料导报》期刊社, 2018, 32(3): 362-367.
[1] Bingwei LUO,Dabo LIU,Fei LUO,Ye TIAN,Dongsheng CHEN,Haitao ZHOU. Research on the Two Typical Infrared Detection Materials Serving at Low Temperatures: a Review[J]. Materials Reports, 2018, 32(3): 398 -404 .
[2] Huimin PAN,Jun FU,Qingxin ZHAO. Sulfate Attack Resistance of Concrete Subjected to Disturbance in Hardening Stage[J]. Materials Reports, 2018, 32(2): 282 -287 .
[3] Siyuan ZHOU,Jianfeng JIN,Lu WANG,Jingyi CAO,Peijun YANG. Multiscale Simulation of Geometric Effect on Onset Plasticity of Nano-scale Asperities[J]. Materials Reports, 2018, 32(2): 316 -321 .
[4] Xu LI,Ziru WANG,Li YANG,Zhendong ZHANG,Youting ZHANG,Yifan DU. Synthesis and Performance of Magnetic Oil Absorption Material with Rice Chaff Support[J]. Materials Reports, 2018, 32(2): 219 -222 .
[5] Ninghui LIANG,Peng YANG,Xinrong LIU,Yang ZHONG,Zheqi GUO. A Study on Dynamic Compressive Mechanical Properties of Multi-size Polypropylene Fiber Concrete Under High Strain Rate[J]. Materials Reports, 2018, 32(2): 288 -294 .
[6] XU Zhichao, FENG Zhongxue, SHI Qingnan, YANG Yingxiang, WANG Xiaoqi, QI Huarong. Microstructure of the LPSO Phase in Mg98.5Zn0.5Y1 Alloy Prepared by Directional Solidification and Its Effect on Electromagnetic Shielding Performance[J]. Materials Reports, 2018, 32(6): 865 -869 .
[7] ZHOU Rui, LI Lulu, XIE Dong, ZHANG Jianguo, WU Mengli. A Determining Method of Constitutive Parameters for Metal Powder Compaction Based on Modified Drucker-Prager Cap Model[J]. Materials Reports, 2018, 32(6): 1020 -1025 .
[8] WANG Tong, BAO Yan. Advances on Functional Polyacrylate/Inorganic Nanocomposite Latex for Leather Finishing[J]. Materials Reports, 2017, 31(1): 64 -71 .
[9] HUANG Dajian, MA Zonghong, MA Chenyang, WANG Xinwei. Preparation and Properties of Gelatin/Chitosan Composite Films Enhanced by Chitin Nanofiber[J]. Materials Reports, 2017, 31(8): 21 -24 .
[10] YUAN Xinjian, LI Ci, WANG Haodong, LIANG Xuebo, ZENG Dingding, XIE Chaojie. Effects of Micro-alloying of Chromium and Vanadium on Microstructure and Mechanical Properties of High Carbon Steel[J]. Materials Reports, 2017, 31(8): 76 -81 .
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed