Materials Reports 2022, Vol. 36 Issue (Z1): 21120243-8 |
INORGANIC MATERIALS AND CERAMIC MATRIX COMPOSITES |
|
|
|
|
|
Influence of Lithium Silicate Mixed Solution on the Wear Resistance of Aggregate Made from Limestone |
LYU Jianwei1, ZHANG Hongliang2, ZHANG Ge3, LI Jiyan2
|
1 Hangzhou Transportation Development Guarantee Center, Hangzhou 310030, China 2 School of Highway,Chang'an University, Xi'an 710054, China 3 Shandong Provincial Communications Planning and Design Institute Co., Ltd, Jinan 250101, China |
|
|
Abstract In order to improve the anti-skid performance of asphalt pavement,the aggregates were soaked in lithium silicate mixed solutions to improve the wear resistance in this work. The aggregates immersed in four kinds of lithium silicate mixed solutions with five different mass ratios were prepared and then initially selected by water immersion test and photoelectric colorimetric test, and then re-selected by Los Angeles abrasion test and polishing value test. The properties of selected aggregates was evaluated by crushing value test and density and water absorption test, and improvement mechanism of the wear resistance of soaked aggregates was explored through infrared spectroscopy test, scanning electron microscope, and AIMS aggregates image measurement system. The results showed that the adhesion and abrasion resistance of the aggregates soaked in the mixed solution of lithium silicate and silicone-acrylic emulsion with a mass ratio of 6∶4 were good, and its adhesion had reached the fifth level, and the abrasion loss had been reduced by about 25%. Solution immersion had little effect on the apparent relative density of the aggregates, but it obviously reduced the water absorption of the aggregates, and improved the crush resistance of the aggregates. The mixed solution of lithium silicate and silicone acrylic emulsion had chemical bond with limestone, which made the mixed solution better adhered to the aggregate surface. Because lithium silicate also had good wear resistance,so the protective layer formed by the mixed solution of lithium silicate and silico-nacrylic emulsion around the aggregate delayed the attenuation of aggregate angularity and surface texture, and improved the ability of aggregate to maintain angularity and surface roughness, so as to improve the wear resistance of aggregate.
|
Published: 05 June 2022
Online: 2022-06-08
|
|
Fund:Zhejiang Transportation Science and Technology Project (2019H11). |
|
|
1 徐金枝, 郝培文, 郭晓刚, 等. 中国公路学报, 2021, 34(10), 72. 2 王端宜, 王刚, 李智, 等. 中国公路学报, 2017, 30(9), 1. 3 Xiong J P, Gong W J, Huang Y T. Advanced Materials Research, 2014, 3470(1030-1032), 1123. 4 耿九光, 兰倩, 刘光军, 等. 应用化工, 2020, 49(4), 1025. 5 董祥, 张士萍, 丁小晴, 等. 公路, 2011, 56(11), 14. 6 黄远殷. 加速磨耗试验与沥青路面表层抗滑研究. 硕士学位论文, 广州大学, 2017. 7 郑典模, 陈创, 陈骏驰, 等. 无机盐工业, 2015, 47(7), 32. 8 陈潇湘, 熊卓, 余学海, 等. 燃烧科学与技术, 2018, 24(3), 257. 9 Charles R J. Journal of the American Ceramic Society, 2006, 46(5), 235. 10 Gransberg D D. In:Development and Practice in Structural Engineering and Construction. Singapore, 2012, pp.383. 11 Riemer C J, Pittenger D, Gransberg D D. In: Transportation Research Board 91st Annual Meeting. Washington, 2012,pp.8. 12 代玉兰, 谢晓丽, 胡志华.西南科技大学学报, 2021, 36(1), 35. 13 蒋乐. 硅酸锂基有机无机复合涂层的制备与性能研究.硕士学位论文, 浙江大学, 2015. 14 吴波, 杜爱琴. 山东大学学报(工学版), 2004, 34(2), 96. 15 Song Z J, Lu Z Y, Lai Z Y,et al. Materials (Basel, Switzerland), 2020, 13(22), 1. 16 韩超, 安丰伟, 韦武举. 公路, 2015, 60(12), 210. 17 郝雪丽, 孙朝云, 耿方圆, 等.华南理工大学学报(自然科学版), 2021, 49(1), 142. 18 李智, 靖红晨, 王子硕. 广西大学学报(自然科学版), 2020, 45(6), 1301. 19 徐冬青, 张东, 庄心怡, 等. 公路交通科技, 2019, 36(6), 1. 20 王旭东. 集料岩性及微观特征对沥青混合料路用性能的影响研究. 硕士学位论文, 吉林大学, 2014. 21 耿超, 包静, 邹鹏, 等. 中国公路学报, 2018, 31(11), 58. 22 杨胜强, 李文辉, 李秀红, 等.表面技术, 2019, 48(10), 13. 23 曹义亲, 曹婷, 黄晓生. 计算机科学, 2019, 46(6), 271. 24 黄果, 蒲亦非,陈庆利, 等. 四川大学学报(工程科学版), 2011, 43(1), 129. 25 张洁玉, 赵鸿萍, 陈曙. 电子与信息学报, 2014, 36(6), 1327. 26 赵小彦. 公路, 2019, 64(2), 220. 27 甘新立. 集料与沥青的表面特性分析及黏附性评价. 硕士学位论文, 长安大学, 2017. 28 任鑫, 胡文全. 高分子材料分析技术, 北京大学出版社, 2012,pp. 72. |
|
|
|