| RESEARCH PAPER |
|
|
|
|
|
| Low Cycle Fatigue Behavior of Al-Zn-Mg-Cu Alloy Containing Zr and Sc |
| ZHANG Xiaoyu1,2, LENG Li3, WANG Zhanjun2
|
1 School of Materials Science and Engineering, University of Science and Technology Beijing, Beijing 100083;
2 Beijing Research Institute of Mechanical & Electrical Technology, Beijing 100083;
3 School of Material Science and Engineering, Shenyang University of Technology, Shenyang 110870 |
|
|
|
|
Abstract The single stage aging and RRA treatment on both microstructure and fatigue properties of Al-Zn-Mg-Cu alloy with Zr and Sc content were investigated through the transmission electron microscope and the low-cycle fatigue tests. In the single aging treatment state, the major precipitates inside the grains are η′ phases, the discontinuous equilibrium phase precipitates at the grain boundaries, and there exist the precipitate free zones near the grain boundaries. For the alloy subject to RRA treatment state, the precipitates both inside the grains and at the grain boundaries obviously grow, and the precipitate free zone widens. Under the low-cycle fatigue loading condition, the alloy with different heat treatment states exhibits mainly the stable cyclic stress response behavior at the total strain amplitudes ranged from 0.4% to 0.7%. However, at the total strain amplitude of 0.8%, the alloy shows mostly the cyclic strain softening followed by the cyclic strain hardening. At the total strain amplitudes from 0.4% to 0.6%, the RRA treatment can effectively prolong the low-cycle fatigue lives of the alloy. The relationships between the plastic strain amplitude, elastic strain amplitude and reversals to failure are linear, and can be described separately with the Coffin-Manson formula and Basquin equations. In addition, the fatigue cracks initiate transgranularly at the free surface of fatigue samples and propagate transgranularly.
|
|
Published: 25 October 2017
Online: 2018-05-05
|
|
|
|
|
1 Dursun T, Soutis C. Recent developments in advanced aircraft aluminum alloys[J]. Mater Des, 2014,56:862.
2 Gonzalo B, Jorge R G, José M. Recent developments in advanced aircraft aluminum alloys[J]. J Mater Eng Perform, 2009,18:1144.
3 Senkov O N, Shagiev M R, Senkova S V, et al. Precipitation of Al3-(Sc,Zr) particles in an Al-Zn-Mg-Cu-Sc-Zr alloy during conventional solution heat treatment and its effect on tensile properties[J]. Acta Mater, 2008,56(15):3723.
4 Zhang W, Xing Y, Jia Z H, et al. Effect of minor Sc and Zr addition on the microstructure and properties of ultra-high strength alloy[J]. Trans Nonferrous Metals Soc China, 2014,24:3866.
5 Dezecot S, Brochu M. Microstructural characterization and high cycle fatigue behavior of invesment cast A357 aluminum alloy[J]. Int J Fatigue, 2015,77:154.
6 Zupanc U, Grum J. Effect of pitting corrosion on fatigue perfor-mance of shot-peened aluminium alloy 7075-T651[J]. J Mater Processing Technol, 2010,210:1197.
7 Han S W, Katsumata K, Kumai S, et al. Effects of solidification structure and aging condition on cuclic stress-strain response in Al-7%Si-0.4%Mg cast alloys[J]. Mater Sci Eng A, 2002,337(1-2):170.
8 Michael D S, Hans J M, Huseyin S. Aphysically based fatigue mo-del for predicition of crack iniation form persistent slip bands in polycrystals[J]. Acta Mater, 2011,59(1):328.
9 Miao J, Pollock T M, Jones J W. Microstructural extremes and the transition from fatigue crack initiation to small crack growth in a polycrystalline nickel-base superalloy[J]. Acta Mater, 2012,60(6-7):2840.
10Kim S W, Han S W, Lee U J, et al. Effect of solidication structure on fatigue crack growth in rheocast and thixocast Al-Mg-Si alloys[J]. Mater Lett, 2004,58(1-2):257.
11Coffin L F. A study of the effects of cyclic thermal stresses on aductile metal[J]. Trans Am Soc Mech Eng, 1954,76:931.
12Adam N, Chalid E D, Heinz K, et al. New method for evaluation of the Manson-Coffin-Basquin and Ramberg-Osgood equations with respect to compatibility[J]. Int J Fatigue, 2008,30(10-11):1967.
13Dai X Y, Xia C Q, Long C G, et al. Morphology of primary Al3-(Sc, Zr) of as-cast Al-Zn-Mg-Cu-Zr-Sc alloys[J]. Rare Matal Mater Eng, 2011,40(2):265(in Chinese).
戴晓元, 夏长清, 龙春光, 等. Al-Zn-Mg-Cu-Zr-Sc合金铸态Al3(Sc,Zr)相形貌的研究[J].稀有金属材料与工程, 2011,40(2):265.
14Wu X M, Wang Z G, Li G Y. Cyclic deformation and strain burst behavior of Cu-7at.%Al and Cu-16at.% single crystals with diffe-rent orientations[J]. Mater Sci Eng A, 2001,314(1-2):39. |
|
|
|
渝公网安备50019002502923号 © Editorial Office of Materials Reports.
2017, Vol. 31 
