马氏体钢和高锰钢在人工海水中的冲刷腐蚀行为研究

doi:10.11896/cldb.24030170

Abstract
Figure/Table
References
Related Citation (6)

Download:

Full Text ( PDF ) (41255KB)
Export: BibTeX | EndNote (RIS)

Abstract In this work, the corrosion, erosion and erosion-corrosion behaviors of two high-strength steels (martensitic steel and high manganese steel) in artificial seawater were studied by using a rotary stirring setup, and the coupling mechanism of local corrosion and erosion of two high-strength steels in artificial seawater was analyzed by combining electrochemistry, weight loss measurement and morphological characterization. The test results show that under pure fluid, high manganese steel has better corrosion-resistance, and its corrosion rate is much lower than that of martensitic steel. After the addition of sand, the corrosion morphology of high manganese steel is similar to that in pure fluids, and all of them are pitting damage, while the corrosion morphology of martensitic changes from “flow mark” to pitting damage. At a low flow rate, the impact of sand is weak, and the corrosion of the two steels is dominant in its erosion-corrosion, and the synergistic effect of corrosion and erosion is very significant, and the loss caused by the synergistic effect is the main reason for the erosion-corrosion loss of the two steels. The electrochemical and weight loss measurements show that the erosion-corrosion rate of high-manganese steel is much lower than that of martensitic steel, but the local morphology characterization results show that the pit depth of high-manganese steel is higher than that of martensitic steel, and it faces a higher risk of perforation. Furthermore, crack development inside the pit may also induce other types of damage. Therefore, in the process of studying erosion-corrosion, we should also pay attention to the local erosion-corrosion.

Key words： martensitic steel high manganese steel artificial seawater erosion-corrosion synergy

Published: 25 April 2025 Online: 2025-04-18

CLC number:

TG178

	Service
	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	ZOU Xiaohui
	LIU Yongfei
	LI Dan
	YAO Haiyuan
	DONG Leilei
	XU Yunze

Cite this article:

ZOU Xiaohui,LIU Yongfei,LI Dan, et al. Study on the Erosion-Corrosion Behavior of Martensitic Steel and High Manganese Steel in Artificial Seawater[J]. Materials Reports, 2025, 39(8): 24030170-8.

URL:

https://www.mater-rep.com/EN/10.11896/cldb.24030170 OR https://www.mater-rep.com/EN/Y2025/V39/I8/24030170

1 Zhao J. Materials Reports, 2018, 32(S1), 428(in Chinese).
赵捷. 材料导报, 2018, 32(S1), 428.
2 Fang H, Liu H, Sun J, et al. Materials Reports, 2023, 37(21), 211(in Chinese).
房洪杰, 刘慧, 孙杰, 等. 材料导报, 2023, 37(21), 211.
3 Teng Y, Zhang H, Ma L, et al. Equipment Environmental Engineering, 2023, 20(8), 53(in Chinese).
滕乙正, 张海兵, 马力, 等. 装备环境工程, 2023, 20(8), 53.
4 Song F, Du L. Journal of Iron and Steel Research, 2014, 26(2), 1(in Chinese).
宋凤明, 杜林秀. 钢铁研究学报, 2014, 26(2), 1.
5 Ren Y, Zhao H, Zhou H, et al. Journal of Chinese Society for Corrosion and Protect, 2021, 41(4), 508(in Chinese).
任莹, 赵会军, 周昊, 等. 中国腐蚀与防护学报, 2021, 41(4), 508.
6 Zhu J, Zhang Q, Chen Y, et al. Journal of Chinese Society for Corrosion and Protect, 2014, 34(3), 199(in Chinese).
朱娟, 张乔斌, 陈宇, 等. 中国腐蚀与防护学报, 2014, 34(3), 199.
7 Yang X, Guan L, Li Y, et al. Journal of Chinese Society for Corrosion and Protect, 2022, 42(6), 979(in Chinese).
杨湘愚, 关蕾, 李雨, 等. 中国腐蚀与防护学报, 2022, 42(6), 979.
8 Peng W, Zhao J, Sun J, et al. Equipment Environmental Engineering, 2021, 18(9), 64(in Chinese).
彭文山, 赵建仓, 孙佳钰, 等. 装备环境工程, 2021, 18(9), 64.
9 Liu X, Peng W, Liu S, et al. Equipment Environmental Engineering, 2019, 16(3), 9(in Chinese).
刘雪键, 彭文山, 刘少通, 等. 装备环境工程, 2019, 16(3), 9.
10 Gao Q, Zeng W, Wang H, et al. Journal of Chinese Society for Corrosion and Protection, 2023, 43(5), 1087(in Chinese).
高秋英, 曾文广, 王恒, 等. 中国腐蚀与防护学报, 2023, 43(5), 1087.
11 Song F, Du L, Sun G, et al. Corrosion Science and Protection Technology. 2018, 30(1), 74(in Chinese).
宋凤明, 杜林秀, 孙国胜, 等. 腐蚀科学与防护技术, 2018, 30(1), 74.
12 Islam M, Jiang J, Xie Y. Wear, 2024, 536-537, 205181.
13 Ren W, Ma H, Cui S, et al. Heat Treatment of Metals, 2 024, 49(1), 61(in Chinese).
任武彬, 麻衡, 崔绍华, 等. 金属热处理, 2024, 49(1), 61.
14 Chung R, Jiang J, Pang C, et al. Wear, 2023, 530, 204885.
15 Park J, Lee S, Choi J, et al. Applied Surface Science, 2023, 637, 157875.
16 Park J, Kim S, Jeong Y, et al. Materials, 2022, 15(5), 1746
17 Zhang Q, Wang Y, Li G, et al. Acta Metallurgica Sinica, 2023, 59(7), 893(in Chinese).
张奇亮, 王玉超, 李光达, et al. 金属学报, 2023, 59(7), 893.
18 Xu Y, Zhang Q, Chen H, et al. Journal of Materials Research and Technology, 2022, 20, 4432.
19 Xu Y, Zhang Q, Zhou Q, et al. npj Materials Degradation, 2021, 5(1), 56.
20 Xu Y, Tan M. Corrosion Science, 2019, 151, 163.
21 Khireche S, Boughrare D, Kadri A, et al. Corrosion Science, 2014, 87, 504.
22 Xu Y, Tan M. Corrosion Science, 2018, 139, 438.
23 Xu Y, Zhang Q, Chen H, et al. Journal of Materials Research and Technology, 2023, 25, 6550.
24 Zhang F, Chen C, Liu S, et al. Steel, 2024, 59(3), 1(in Chinese).
张福成, 陈晨, 刘帅, 等. 钢铁, 2024, 59(3), 1.
26 Owen J, Ramsey C, Barker R, et al. Wear, 2018, 414-415, 376.
25 Xu Y, Zhang Q, Gao S, et al. Wear, 2021, 478-479, 203907.
27 Evans U R. Journal of the Electrochemical Society, 1961, 108(4), 94C.
28 Wang L, Xin J, Cheng L, et al. Corrosion Science, 2019, 147, 108.