METALS AND METAL MATRIX COMPOSITES |
|
|
|
|
|
Influence of Pre-corrosion and Pre-fatigue on Fretting Fatigue Behavior of 30CrMnSiA Bolt Steel |
YANG Tingyong1,*, LUO Wei1, FENG Lijun2, ZHAO Weidong3, LIU Daoxin4, DENG Wen1, ZHANG Chao1
|
1 China Helicopter Research and Development Institute, Jingdezhen 333001, Jiangxi, China 2 Southwest Technology and Engineering Research Institute, Chongqing 400039, China 3 College of Mechanical and Vehicle Engineering, Taiyuan University of Technology, Taiyuan 030024, China 4 School of Civil Aviation, Northwestern Polytechnical University, Xi'an 710072, China |
|
|
Abstract To investigate the fretting fatigue behavior of 30CrMnSiA high-strength bolt steel under marine environmental service conditions, the influence and mechanism of pre-corrosion, pre-fatigue, and their combined effects on the fatigue damage behavior of 30CrMnSiA high-strength steel were studied by using analysis methods such as scanning electron microscopy, energy dispersive spectroscopy, electrochemical impedance spectroscopy. The results showed that, under the experimental conditions here, the damage mode of 30CrMnSiA high-strength bolt steel is fretting fatigue. With the increase of pre-corrosion time, the fretting fatigue life of 30CrMnSiA high-strength bolt steel gradually decreased, and the average fretting fatigue life of bolts decreased by 73.69% after 6 days pre-corrosion. Under the same pre-corrosion experimental conditions, as the number of pre-fatigue cycles increased, the fretting fatigue life of bolts gradually decreased; however, the fretting fatigue life of bolts with 10 000 pre-fatigue cycles and 2 days of pre-corrosion is a little higher than that of bolts with only 2 days of pre-corrosion. The more pre-fatigue cycles and the longer the pre-corrosion time, the bolt had shorter fretting fatigue life. After 40 000 cycles of pre-fatigue and 4 days of corrosion, the fatigue life of bolts decreased by 86.4%. The reason was that pre-corrosion and its combined effect with pre-fatigue usually promoted the initiation and propagation of fatigue cracks on the surface of 30CrMnSiA high-strength bolt steel, which led to a reduction of their fretting fatigue life. Ho-wever, when the pre-fatigue cycle was small, micro wear was lighter and had a certain leveling effect on the bolt surface, thereby alleviated the adverse effects of corrosion. As a result, the fretting fatigue life of bolts is slightly longer than that of simply pre-corrosion bolts.
|
Published: 10 December 2024
Online: 2024-12-10
|
|
Fund:National Natural Science Foundation of China (52271071). |
|
|
1 Liu X C, Chen X J, Liang Z W, et al. Metals, 2022, 12(10), 1713. 2 Kong Y, Liu Z, Liu Q. Spray Technol, 2022, 31, 2136. 3 Liu X C, Chen X J, Liang Z W, et al. Material, 2022, 15(20), 7380. 4 Li F, Zhang S D, Zhu C C, et al. Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2022, 16(1), JAMDSM0009. 5 Mohamed E M, Thierry P L. International Journal of Fatigue, 2013, 47, 330. 6 Seth J P, Rita B F, Mark D S. Coatings, 2017, 7(2), 25. 7 Yang X K, Zhang L W, Liu M, et al. Corrosion Engineering, Science and Technology, 2017, 52(3), 226. 8 Yu H, Liu X T, Yang G H, et al. Journal of the Brazilian Society of Mechanical Sciences, 2024, 46(4), S40430-024-04793-2. 9 Ye G N, Chen Y L. Advances in Aeronautical Science and Engineering, 2011, 2(1), 66(in Chinese). 叶广宁, 陈跃良. 航空工程进展, 2011, 2(1), 66. 10 Chen G, Lu L L, Cui Y, et al. International Journal of Fatigue, 2015, 80, 364. 11 Botvina L R, Beletsky E N, Tyutin M R, et al. Physical Mesomechanics, 2023, 26(4), 391. 12 Zhang W F, Gao X Y, Liu X P, et al. Materials Science Forum, 2020, 984, 4. 13 Yang Y, Zhao J J, Yang X K, et al. Equipment Environmental Enginee-ring, 2017, 14(3), 57(in Chinese). 杨祎, 赵俊军, 杨小奎, 等. 装备环境工程, 2017, 14(3), 57. 14 Li N, Zhang W F, Xu H, et al. Materials, 2022, 15(2), 629. 15 Luo L Z, Zhou K, Li X F, et al. IOP Conference Series: Materials Science and Engineering, 2021, 1043(3), 032044. 16 Yang G H, Liu X T, Lai J F, et al. Advances in Mechanical Engineering, 2022, 14(6), 16878132221104307. 17 Zhang H W, He Y T, Fan C H, et al. Acta Aeronautics et Astronautics Sinica, 2013, 34(5), 1114(in Chinese). 张海威, 何宇廷, 范超华, 等. 航空学报, 2013, 34(5), 1114. 18 Behvar A, Haghshenas M. The Journal of Space Safety Engineering, 2023, 10(3), 284. 19 The General Reserve Department of PLA. Laboratory environmental test methods for military material Part 11-Salt spray, China, 2009(in Chinese). 中国人民解放军总装备部. 军用装备试验室环境试验方法第11部分 盐雾试验, 2009. 20 Liu W T, Li Y H. Aircraft structure calendar life evolution technology, Aeronautics Industry Press, China, 2004(in Chinese). 刘文珽, 李玉海. 飞机结构日历寿命体系评定技术, 航空工业出版社, 2004. 21 Zhang H W, He Y T, Wu L M, et al. Chinese Journal of Applied Mechanics, 2012, 29(5), 589(in Chinese). 张海威, 何宇廷, 伍黎明, 等. 应用力学学报, 2012, 29(5), 589. 22 Tintero D L, Benito E K, Maunahan H S. Journal of Engineering Research, 2023, 11(1), 100005. 23 Hao X L, Liu J H, LI S H, et al. Journal of Aeronautical Materials, 2010, 30(1), 67(in Chinese). 郝雪龙, 刘建华, 李松海, 等. 航空材料学报, 2010, 30(1), 67. 24 Luo Q H, Zhao Z Y, He Z Q, et al. Journal of Aeronautical Materials, 2017, 37(6), 34(in Chinese). 罗庆洪, 赵振业, 贺自强, 等. 航空材料学报, 2017, 37(6), 34. 25 Sun T, Song R B, Yang F Q, et al. Acta Metallurgica Sinica, 2014, 50(11), 1327(in Chinese). 孙挺, 宋仁伯, 杨富强, 等. 金属学报, 2014, 50(11), 1327. 26 Davison C R, Rutke T. Journal of Engineering for Gas Turbines and Power, 2013, 136(8), 1. 27 Chen J, Yan F Y. Transactions of Nonferrous Metals Society of China, 2012, 22 (6), 1356. 28 Xu L, Chen Y L, Zhang Y, et al. Journal of Nanjing University of Aeronautics & Astronautics, 2014, 46(3), 403(in Chinese). 徐丽, 陈跃良, 张勇, 等. 南京航空航天大学学报, 2014, 46(3), 403. 29 Latifi A, Imanii M, Khorasani M T, et al. Surface & Coatings Technology, 2013, 221 (5), 1. 30 Chen J, Li Q A, Zhang Q, et al. Journal of Chinese Society for Corrosion and Protection, 2014, 34(5), 433(in Chinese). 陈君, 李全安, 张清, 等. 中国腐蚀与防护学报, 2014, 34(5), 433. 31 Du C H, Bai X Q. Lubrication Engineering, 2021, 46(2), 121(in Chinese). 杜琮昊, 白秀琴. 润滑与密封, 2021, 46(2), 121. |
|
|
|