MgO纳米颗粒对AZ31B镁合金微弧氧化涂层耐磨和耐蚀性的影响

doi:10.11896/j.issn.1005-023X.2018.16.012

Abstract
Figure/Table
References
Related Citation (15)

Download:

Full Text ( PDF ) (3055KB)
Export: BibTeX | EndNote (RIS)

Abstract To further improve the corrosion and wear resistance of AZ31B magnesium alloy, the oxide ceramic coatings were fabricated through micro-arc oxidation, and MgO nanoparticles (4 g/L) were added into the electrolyte. The surface and cross-sectional morphology were observed by scanning electron microscopy. The phase composition was measured by X-ray diffraction. The corrosion resistance was tested by electrochemical workstation and salt spray test. The abrasion resistance was tested using pin on disk test. The results indicate that with addition of the MgO nanoparticles, the corrosion current density is reduced to 4.28×10^-9 A/cm², due to the micropores are significantly sealed and the MgO, as one of the components of the coatings is increased. The results of neutral salt spray show that the corrosion takes place in the form of pitting and crack, and the deposition of MgO reduces the corrosion point. Under dry friction of 2 N, with the increase of the thickness of the inner dense layer, the friction coefficient and the wear rate decreased to 0.228 and 1.39×10^-5 mm³/(N·m), respectively. The corrosion and wear resistance are effectively improved.

Key words： magnesium alloy micro-arc oxidation MgO nanoparticles corrosion resistance wear resistance

Published: 18 September 2018

CLC number:

TG174.45

	Service
	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	MA Niu
	HUANG Jiamu
	SU Jun
	YIN Lingyi

Cite this article:

MA Niu,HUANG Jiamu,SU Jun, et al. Effects of MgO Nanoparticles on Corrosion and Wear Behavior of Micro-arc Oxide Coatings Formed on AZ31B Magnesium Alloy[J]. Materials Reports, 2018, 32(16): 2768-2772.

URL:

http://www.mater-rep.com/EN/10.11896/j.issn.1005-023X.2018.16.012 OR http://www.mater-rep.com/EN/Y2018/V32/I16/2768

1 Yu L, Cao J, Cheng Y. An improvement of the wear and corrosion resistances of AZ31 magnesium alloy by plasma electrolytic oxidation in a silicate-hexametaphosphate electrolyte with the suspension of SiC nanoparticles[J]. Surface & Coatings Technology,2015,276:266.
2 Cui X J, Wei J S, Ning C M, et al. Effects of nitrogen volumetric flow rate on properties of MAO/TiN composite coatings on AZ31B magnesium alloy[J]. China Surface Engineering,2017,30(2):27(in Chinese).
崔学军,魏劲松,宁闯明,等.氮气流量对AZ31B镁合金表面MAO/TiN涂层性能的影响[J].中国表面工程,2017,30(2):27.
3 Chen C, Zhang Y P, Chen W W, et al. Preparation and properties of blue ceramic coating by micro-arc oxidation on aluminum alloy[J]. Materials Review B:Research Papers,2017,31(5):121(in Chinese).
陈超,张玉平,陈为为,等.铝合金表面蓝色微弧氧化陶瓷膜的制备及性能研究[J].材料导报:研究篇,2017,31(5):121.
4 Cui L Y, Zeng R C, Guan S K, et al. Degradation mechanism of micro-arc oxidation coatings on biodegradable Mg-Ca alloys: The inf-luence of porosity[J]. Journal of Alloys & Compounds,2016,695:2464.
5 Cui L Y, Gao S D, Li P P, et al. Corrosion resistance of a self-hea-ling micro-arc oxidation/polymethyltrimethoxysilane composite coa-ting on magnesium alloy AZ31[J]. Corrosion Science,2017,118:84.
6 Zhang R F, Wang F Y, Hu C Y, et al. Research progress in sealing treatment of anodic coatings formed on magnesium alloys[J].Journal of Material Engineering,2007(11):82(in Chinese).
张荣发,王方圆,胡长员,等.镁合金阳极氧化膜封孔处理的研究进展[J].材料工程,2007(11):82.
7 Narayanan T S N S, Min H L. A simple strategy to modify the po-rous structure of plasma electrolytic oxidation coatings on magnesium[J]. RSC Advances,2016,6(19):16100.
8 Li Z, Jing X, Yuan Y, et al. Composite coatings on a Mg-Li alloy prepared by combined plasma electrolytic oxidation and sol-gel techniques[J]. Corrosion Science,2012,63:358.
9 Lu X P, Mohedano M, Blawert C, et al. Plasma electrolytic oxidation coatings with particle additions—A review[J]. Surface & Coa-tings Technology,2016,307:1165.
10 Aliofkhazraei M, Gharabagh R S, Teimouri M, et al. Ceria embedded nanocomposite coating fabricated by plasma electrolytic oxidation on titanium[J]. Journal of Alloys & Compounds,2016,685:376.
11 Zhao J, Xie X, Zhang C. Effect of the graphene oxide additive on the corrosion resistance of the plasma electrolytic oxidation coating of the AZ31 magnesium alloy[J]. Corrosion Science,2017,114:146.
12 Lee S J, Toan D L H. Effects of copper additive on micro-arc oxidation coating of LZ91 magnesium-lithium alloy[J]. Surface & Coa-tings Technology,2016,307:781.
13 Vakili-Azghandi M, Fattah-Alhosseini A, Keshavarz M K. Effects of Al₂O₃ nano-particles on corrosion performance of plasma electrolytic oxidation coatings formed on 6061 aluminum alloy[J]. Journal of Materials Engineering & Performance,2016,25(12):5302.
14 Vatan H N, Ebrahimi-Kahrizsangi R, Kasiri-Asgarani M. Structu-ral, tribological and electrochemical behavior of SiC nanocomposite oxide coa-tings fabricated by plasma electrolytic oxidation (PEO) on AZ31 magnesium alloy[J]. Journal of Alloys & Compounds,2016,683:241.
15 Zhang R H, Zhao J, Liang J. A novel multifunctional PTFE/PEO composite coating prepared by one-step method[J]. Surface & Coa-tings Technology,2016,299:90.
16 Schneider M, Kremmer K, Hǒhn S. Corrosion protection of thickness reduced plasma electrolytic layers on AZ31[J]. Materials & Corrosion,2016,67(9):921.
17 Lai X M, Kang Z X, Li Y Y. Duplex surface modification combined with micro-arc oxidation and polymer plating on AZ31 magnesium alloy and their functional properties[J]. Chinese Journal of Nonferrous Metals,2011,21(6):1299(in Chinese).
赖晓明,康志新,李元元.AZ31镁合金微弧氧化与有机镀膜的复合表面改性及功能特性[J].中国有色金属学报,2011,21(6):1299.
18 Asgari M, Aliofkhazraei M, Darband G B, et al. Evaluation of alumina nanoparticles concentration and stirring rate on wear and corrosion behavior of nanocomposite PEO coating on AZ31 magnesium alloy[J]. Surface & Coatings Technology,2017,309:124.
19 Arrabal R, Matykina E, Skeldon P, et al. Incorporation of zirconia particles into coatings formed on magnesium by plasma electrolytic oxidation[J]. Journal of Materials Science,2008,43(5):1532.
20 Arrabal R, Matykina E, Viejo F, et al. AC plasma electrolytic oxidation of magnesium with zirconia nanoparticles[J]. Applied Surface Science,2008,254(21):6937.
21 Shin K R, Namgung S, Yoo B, et al. Electrochemical response of ZrO₂-incorporated oxide layer on AZ91 Mg alloy processed by plasma electrolytic oxidation[J]. Surface & Coatings Technology,2011,205(13-14):3779.
22 Arun S, Arunnellaiappan T, Rameshbabu N. Fabrication of the na-noparticle incorporated PEO coating on commercially pure zirconium and its corrosion resistance[J]. Surface & Coatings Technology,2016,305:264.
23 Yin Z Z, Zeng R C, Cui L Y, et al. Progress on phosphate coatings on biodegradable magnesium alloys[J].Journal of Shandong University of Science and Technology(Natural Science),2017,36(2):57(in Chinese).
殷正正,曾荣昌,崔蓝月,等.医用可降解镁合金表面磷酸盐涂层研究进展[J].山东科技大学学报(自然科学版),2017,36(2):57.
24 Cui L Y, Wu S S, Xu L F, et al. Induction effect of layer-by-layer assembled PAH/PSS multilayers to construct Ca-P coating on magnesium alloy[J].Surface Technology,2017,46(3):34(in Chinese).
崔蓝月,吴思思,徐丽粉,等.镁合金表面层层组装PSS/PAH膜诱导钙磷涂层[J].表面技术,2017,46(3):34.
25 Ko Y G, Namgung S, Dong H S. Correlation between KOH concentration and surface properties of AZ91 magnesium alloy coated by plasma electrolytic oxidation[J]. Surface & Coatings Technology,2010,205(7):2525.
26 Wang Y Q, Wang Y, Chen P M, et al. Microstructure, corrosion and wear resistances of microarc oxidation coating on al alloy 7075[J]. Acta Metallurgica Sinica,2011,47(4):455(in Chinese).
王艳秋,王岳,陈派明,等.7075铝合金微弧氧化涂层的组织结构与耐蚀耐磨性能[J].金属学报,2011,47(4):455.
27 Yang Qing, Gou Yinning, Su Yongyao,et al. Investigation of anodic oxidation of ultra-fine grained magnesium alloy obtained by extrusion and shearing process[J]. Journal of Chongqing University of Technology(Natural Science),2017(12):58(in Chinese).
杨卿,沟引宁,苏永要,等.挤压-剪切镁合金的阳极氧化研究[J].重庆理工大学学报(自然科学),2017(12):58.